Ugliest RB on the planet...
Ugliest RB on the planet...
What does a crap car look like after getting really bad cosmetic upgrades? we all know that answer... but this is one for the books... Remember, this started life as an RB....
Original articles here http://addmorehp.com/2006/07/26/holden-altis-remember/ & here http://addmorehp.com/2006/06/13/holden- ... den-aerio/
I honestly didn't think the RB could get any worse but i proved myself wrong... ergh....
Original articles here http://addmorehp.com/2006/07/26/holden-altis-remember/ & here http://addmorehp.com/2006/06/13/holden- ... den-aerio/
I honestly didn't think the RB could get any worse but i proved myself wrong... ergh....
[ [FAN74] - Slide the fun! ]
84 TG - G180, 5spd, big valve head, and then some...
84 TG - G180, 5spd, big valve head, and then some...
id take that over the old one, at least you'd be to sell it for more
got my te gemi for $220
new coupe... project under construction
http://www.ozgemini.com/forums/non-tech ... ight=fazio
new coupe... project under construction
http://www.ozgemini.com/forums/non-tech ... ight=fazio
-
- Was dangerous_dave
- Posts: 2032
- Joined: Mon May 30, 2005 12:38 am
- Location: MEL
x 2 its a fantastic job... it looks like a 2004+ model car...gemhead wrote:thats alot of work, from the front and back it loks brand new
but why the f*#k would you want a 2004+ looking car with a SOHC 1.5ltr carburetted engine?
(assuming it doesnt have a crazy conversion done to it)
still a pox FWD
Gemini: Light weight, low cost RWD automotive platform.
-
- Long Term Member
- Posts: 4173
- Joined: Mon May 23, 2005 8:33 pm
id be interested to see it up close and in person, i mean, it looks like a factory job.
A chinese factory rip off job, but still, look at the panel gaps and finish on it, its friggin seamless.
I guess its also the difference in quality of work that people are prepared to do in different countries, that car is in Jakarta? but obvioulsy it was still financially worth it. here, every panel shop would say "Why bother, its not worth it, it'd cost too much, just buy a new car" Because they are lazy and couldn't care, and think that no-one in their right mind would spend that much (which they probably wouldn't)
Another good example is that bloke in Croatia doing up the kadett, or that wagon from brazil that had most of the body replaced.
A chinese factory rip off job, but still, look at the panel gaps and finish on it, its friggin seamless.
I guess its also the difference in quality of work that people are prepared to do in different countries, that car is in Jakarta? but obvioulsy it was still financially worth it. here, every panel shop would say "Why bother, its not worth it, it'd cost too much, just buy a new car" Because they are lazy and couldn't care, and think that no-one in their right mind would spend that much (which they probably wouldn't)
Another good example is that bloke in Croatia doing up the kadett, or that wagon from brazil that had most of the body replaced.