OzGemini.com

Ahhh car part porn

I take it your staying PRC, Do they allow for more mods in AMSAG

Yeah PRC still, it's under CAMS so you qualify
for many more events.
AMSAG is good & has more freedom in regards
to engines, but suspension mods are similar to
PRC still.

That flywheel!!!
I just browsed the Jun website for 30 mins.. That place is awesome.
How much they do they charge for cams ?

Yeah I just want to mount it on the wall
& look at it!!!
The cams I got made where re-profile std
cams, as no one makes new blanks.
The cam profiles where developed with JUN
Auto & my mate in Japan. So they aren't an
'off the shelf' item.
They where around $1200 plus the AUD$ is
shithouse now anyway

New CP pistons have arrived, bottom end can
now begin

Old vs New



Compression ratio of 11.0:1, so more piston up top.



A fair old weight saving too (not including the rings & bearings)

Wow thats awesome .
I want this , merry xmas ..

Do you know if CP have the combustion chamber shapes on file for G180w ?

Merry Xmas mate ,
Yep CP have everything you need to get
pistons made for a g180W. They had never
made pistons for a G200W before. They
needed a sample & had to adjust some things
on the G180W measurements.

Hey mate sort of cost are the pistons and rods . Are they oversize . And can you give me a contact at CP.
cheers Ian

Yeah the pistons are 87.5mm, 0.5mm oversize.
They where made to my specs & around $1300.

The only conrods that are a direct replacement
for the G200W are the Spool conrods.
I used Carrillo Toyota conrods & they where $1300
too.

I went direct to CP, but SPOOL Imports have done
quite a few CP Pistons for G180W & have all of the
drawings for them.

New intake trumpets turned up this week. 50mm long billet aluminium.
Cylinder head is now complete ready to go, Camshafts, valves, springs, etc

all looks nice

x2!

Getting close now!

What are you going to do on the ignition side of things, or did i miss it somewhere?

Carby porn! Loving it!

With the ignition I think I will look at a SOHC 'G' series
dizzy or a Nissan Pulsar one to make fit.

Then I will run the MSD 6AL2 unit with the optical pickup
in the dizzy as what was on the old G200 SOHC.
It worked very well & had not one issue with it.