OzGemini.com

Hey guys,

Does anyone here have a gilmore drive on there gemini, what exactly are they and what do they do besides make your car have a supercharged sound??? Pics if possible

Thanks

My pistons say:

RA2586X 1.0 RIB 0.025NK

What pistons are they, any idea???

cheers, thanks man, i will chack as soon as i get home.......

how can i tell if my bottem end has been bored out??? is there a way i could measure or tell???

cheers

I have just ripped apart my motor for a full rebiuld.....the motor had leaks and oil all over it......but for some reason pulled harder then alot of my other stock gemis????

The i saw it had a set of flat top pistons!!!....how can i measure if it has been bored out???can i???

cheers

Has anyone used the baryded hose covers on there gemini engine?

Is it worth getting it, thery are about 60 bucks from supercheap/repco, they look nice but will the fade with all the egine heat, or even rust out???

Anyone using this in there gem?

hey guys, my gemini used to have a rotar in it, but while its getting rebuilt the stockar is gonna be used temporarily It had the hydralic clutch before in it......can i keep this for the 1600 5 speed box, or will i have to convert it back to cable :?: will i have to change the whole pedal set up :?...

how much r u asking ??? what motor/box in it now???? diff???

I was going to buy some rims off ebay today,

"The inside of the rim says P1081, 18 x 7.5JJ,They were on a 2004 KIA Carnival, I have been told by several tyre shops that they are a ford stud pattern" 18 inch

any one know if they will fit a gemi stud pattern?

does anyone think it is a waste of time running a gem down the quarter? dont wanna humiliate myself when im up against turboed cars etc anyone know what i could run??? 1.6L Just Reconditoned/Serviced TX Sedan, stock wheels, diff Stage 3 Cam Shaft 4 into 1 extractors 2.5 inch straight exhaust system ...

i am in the process of rebuilding my gem motor, done know too much about porting and polishing.....what will it do...speed, sound???

im running extractors, twin dellorto webbers, 2.5inch exhasut, stage 3 cam

....where can i get this done in sydney and for how much?????

cheers

i suppose it is what you want to use it for, if it is an every day car or a resto job. Personally I would never buy one again, the guy actually recomended that i leave it in the sun for a while so it can stretch before i install it ..... half an our later it discoloured LOL (white), my mate bought o...

i bought one off ebay from that guy..........personally big mistake cost me 110.

cheap vinal used...not a good fit...i would have preferred to pay 300 and get a proper one installed and fitted

cheers man....you wouldnt know what a reasonable price would be to pay ???

i wanted a rough idle, nice sound.........

hey guys im in the process of rebuiding my G161 i wanted to put an after market cam shaft in the car.....anyone got any recomendations???? my mods are a 2.5inch straight exhaust system with dumpy tip, 4 into 1 extractors, 40mm delorto twin webbers with ram tubes + custom inlet manifold. i know there...