OzGemini.com

Do you think posts should become uneditible after a certain amount of time? As many of you are aware, a user is going through systematically editing all the information out of his posts. This has happened a few times in the past by multiple users. As site adminitrators we would prefer this kind of t...

There are wires for the electronic choke, which is operated by a heated coil. Then there's an enriching solenoid and I think a fuel cutoff solenoid.
From memory I can't tell you which wires are which .

OTD 079 wrote:Could go with the panels, then fit cool 1970's bubble glass on each side to satisfy the criteria...

No... Actually - don't do that

hahaha great idea

Have a look at the ramflo range, I believe they have some pretty short filters

Consider it sticky

I always ran the fuel return line on my twins so I suspect the pressure was well below the magic 4 PSI, I assume it would have been around 1-2 PSI or less. In the 5 years I ran that setup I never had a fuel problem. I ran both AVGAS & Unleaded without a problem. AVGAS is quite similar to pump fu...

There is also a bigger breather on the back of the rocker cover, just like the G series.
Why does it need to have 2? Wouldn't the big one on the back be enough?

Have you still got the fuel return line plumbed in? if you do, there's no way the fuel pump could be the cause of the problem. When I had twin 40's the stock pump couldn't feed them (at stock voltage). Are you sure it's flooding? I'm not sure which relay article you read but I assume it would be pro...

When I had twin webers I had a carter pump in mine too. It was also noisy but it didn't bother me.
I never ran a pressure regulator, I just kept the fuel return line plumbed in.

Bugger. Cheers for the info, I'll have to find myself a replacement!

Does anyone have a diagram of the internals of one of these? The brake switch that's in the middle of it on the top is loose and doesn't appear to be tightening up. I assume this is not good. Also when I press the brake pedal there's a 'squishy' air noise that I think comes from the bias valve.... I...

the HSV placard only goes up to 235/40R18 which is what I have anyway

Is it illegal to remove them or replace them with a different placard?

Situation being, I had some repair work done on the door of my SS and when they repainted it they put a HSV placard on it. I'm not happy about it and would like an original one put on.

Is what they've done actually illegal?

It's working fine for me

log?

Send me a PM with what stickers you'd like